Table of Contents
Advertisement
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
5.
Remove the access panel.
6.
Use a T-10 Torx screwdriver to remove the universal media bay blank.
7.
Use a T-10 Torx screwdriver to install the 2 SFF NVMe drive cage.
8.
Remove the primary PCI riser cage (Remove the primary PCI riser cage).
9.
Use a T-15 Torx screwdriver to remove the existing riser board.
Hardware options installation
76
Advertisement
Table of Contents
