Fisher & Paykel RS2484S Installation Manual page 42

Tools Adjusting the height of door the panel
Ensure the side brackets are loosely screwed when adjusting the height of the door
panel. Do not adjust the door panel height when the side brackets are screwed
tight. This can generate friction which causes the hanging brackets to bend.
Cross-head
screwdriver
M4 hex key (1)
1/2" (13mm) spanner
(1x)
Adjust the depth of door panel
42
Illustrations may differ from your purchased appliance.
DOOR PANEL INSTALLATION
Turn the adjustment screw to raise
or lower the height of the door panel
relative to the door.
Continue adjustment until gap with
cabinetry is more than 1/8" (3mm).
Do not adjust the adjustment screw
higher than 1/4" (6.5mm) from its
fully down position.
Loosen side screws on the side
brackets, and slide door panel
forward/backward.
Re-tighten once satisfied.
Adjusting the width of the door panel
To adjust the door panel further,
loosen the M8 washer and nut and
slide the door panel to suit. If further
adjustment is still required, remove the
door panel then loosen the fixing
screws of the hanging bracket and
move bracket sideways to suit.
Once satisfied with door panel
position, fully tighten M8 washer and
nut to adjustment screw.