Cavity Preparation - Fisher & Paykel RS2484S Installation Manual

Anti-tip bracket Attaching the anti-tip bracket
assembly kit
Anti-tip bracket (1x)
Masonry plug (4x)
1
#10x40
cross-head screw
(4x)
Tools
Cross-head
screwdriver
2
Powered drill
Pencil
3
30
Illustrations may differ from your purchased appliance.
back wall
overhead
cabinetry
Measure the height (A) of the attachment
location from the floor to the alcove
return.
A
The height (A) must not exceed
84 3/16" (2138mm) to ensure the
appliance does not tip over during
installation.
Floor
PROFILE VIEW
Mark a horizontal line (B) at the back wall.
Ensure there is a stud behind the wall.
B
Place the bracket to the backwall. Align
min 7 3/4" the undersurface of the bracket along the
(197mm)
marked line.
Mark screw hole locations, and drill screw
holes with powered drill.
bracket

CAVITY PREPARATION

4
5
For solid wall installation
Drill holes suitable to the size of the
masonry plugs.
Hammer 10x30mm masonry plugs into
wall until flush. Fix bracket to wall with
#10x40mm cross head screws, and screw
tightly.
For plaster board wall
Fix the anti-tip bracket to the wall with
#10x40mm cross head screws, and screw
tightly with a screwdriver.
When rollng the appliance into the
cabinetry, ensure the anti-tip bracket
overlaps the back edge of the appliance.
The bracket must overlap the appliance
by a minimum 7 1/16" (180mm) for a
secure hold.
If minimum 7 1/16" (180mm) overlap
cannot be achieved, install a solid spacer
to the wall stud behind the bracket.
Be careful not to run over the power
cord when rolling in the appliance.