Removal Of The Door Lock Assembly - Fisher & Paykel DCS WOSV230 Service Manual

8.20 Removal of the Oven Door Lock Assembly
The door lock is situated on the left hand side of
the product. If the door lock is engaged and the
door cannot be opened, refer to the following
procedure.
1. Remove the oven from the joinery. Refer to
Section 8.1 on pg. 49.
2. Remove the front door lock inspection
panel on the side
3. Remove the link pin retaining ring and
disconnect the link arm
Note: Take care not to lose the link pin or
retaining ring.
The door lock will now be free to disengage.
If the door lock needs to be replaced, refer to
following procedure.
Removal of lock assembly
1. Remove the service panel from the top of
the unit to access the power board. Refer
to Section 8.6 on pg. 54.
2. Remove the door switch wiring harnesses
from the power board
3. Remove the wiring harness to the lock
motor
4. Remove the rear cover
5. Remove the front and rear door lock
assembly retaining screws
6. Remove the wire connector from the door
switch. (This is only necessary for
the upper door lock on a double oven.)
7. Slide the door lock assembly out the rear of
the side panel
Note: Take care not to lose the door switch
spring when removing the door lock assembly.
Reassembly
Refit in reverse manner.
Link arm
Retaining
ring
Door lock
harness
Screw
62