Removal Of The Broil Element; Removal Of The Bake Element - Fisher & Paykel DCS WOSV230 Service Manual

8.14 Removal of the Broil Element

1. Ensure the product is isolated from the power
supply.
2. Remove the oven doors and racks
3. Remove the fan shroud. Refer to Section 8.9
on pg. 56.
4. Remove the 2 screws securing the element to
the cavity rear wall and the 2 screws on the
support frame on the cavity roof
5. Pull the tail of the element through the hole in
the cavity until the terminals are accessible
Note: Tilt the element forward so that the element
terminals will clear the hole in the oven cavity.
6. Disconnect the wiring and connect the
replacement element
7. Reassemble in reverse order

8.15 Removal of the Bake Element

1. Ensure the product is isolated from the power supply
2. Remove the product from the joinery. Refer to Section 8.1 on pg. 49.
3. Remove the rear panel to gain access to the element
4. Remove the 2 ducting sections on left hand side (1 on a single oven)
Single models and lower cavity elements
5. Remove the wiring from the element and remove the screw securing the element to the support
bracket
6. Remove the 2 screws retaining the support bracket to the rear chassis and bend the bracket
downwards enough to clear the element
7. Pull the element out from under the cavity
Double model upper cavity
8. Remove the wiring to the lower vent fan
9. Remove the lower vent fan by removing the 2 screws that secure it (see Section 8.17 on pg. 60)
10. Remove the 2 screws retaining the cooling fan cover
11. Pull the fan cover with the cooling fan attached upward to clear the locating tabs
12. Allow the fan cover to drop down to clear the element
13. Remove the element retaining screw
14. Pull the element out from under the oven cavity
15. Reassemble in reverse order
Note: When reinserting the element, use a wide flat blade or similar object, to lift the cavity insulation
clear of the replacement element.
Element screws
Support frame
screws
59