Removal Of The Fan Shroud; Removal Of The Temperature Sensor - Fisher & Paykel DCS WOSV230 Service Manual

8.9 Removal of the Fan Shroud

1. Ensure the product is isolated from the power
supply
2. Remove the oven door and racks
3. Remove the two screws on either side at the
top of the fan shroud
4. Pull the shroud up slightly to remove the
lower tabs from the cavity liner
5. Reassemble in reverse order

8.10 Removal of the Temperature Sensor

1. Ensure the product is isolated from the power
supply
2. Remove the oven doors and racks
3. Remove the fan shroud. Refer to Section 8.9
above
4. Remove the 2 screws securing the temperature
sensor, and pull forward to release. The
harness connection is a tight fit, but will come
through the cavity access hole.
5. Unplug the harness to release the sensor
6. To test the temp sensor, refer to Section 4.8 on
pg. 14
7. Reassemble in reverse order
Harness
connection
56