Oven Door Lock Assembly - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven

7.24 Oven Door Lock Assembly

Location: Left hand side panel
If the door lock is engaged and the door cannot be opened, refer to the following
procedure.
1. Remove the oven from the joinery cavity. (refer to Section 7.1)
2. Remove the front door lock inspection panel.
3. Remove the link pin cir-clip and disconnect the link arm.
Note: Take care not to lose the link pin cir-clip or pin.
The door lock will now be free to disengage.
If the door lock needs to be replaced refer to following procedure.
Removal
1. Follow the general servicing instructions for components around the back panel and
service panel areas. (refer to Sections 7.3 & 7.4)
2. Remove the door switch and lock motor wiring harnesses from the power module and
disconnect the two wires from the isolating relay.
3. Remove the front and rear door lock assembly retaining screws.
4. Remove the wire connector from the door switch. (This is only necessary for the
upper door lock on a double oven.)
5. Slide the door lock assembly out the rear of the side panel.
Note: Take care not to lose the door switch spring when removing the door lock
assembly.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
Note: Ensure the isolating relay wires are connected.
62
July 2006
Figure 7.24