I Scan Resume Condition - Icom IC-V8000 Instruction Manual

I Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (p. 44)
q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] several times until
"SCT" or "SCP" appears as shown above.
• When "d" is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 46)
e Rotate the tuning dial to set the desired timer:
• "SCT-15" : Scan pauses 15 sec. while receiving a signal.
• "SCT-10" : Scan pauses 10 sec. while receiving a signal.
• "SCT-5" : Scan pauses 5 sec. while receiving a signal.
• "SCP-2" : Scan pauses until the signal disappears and then
resumes 2 sec. later.
r Push [TONE(T-SCAN)] to exit set mode.
SET MODE
USING
The display shows that the
scan will resume 15 sec.
after it stops.
z Push [
B(D-OFF)] to enter set mode.
SET
SET
x Push [
B(D-OFF)] or [
SET
B
times until "SCT" or "SCP" appears as shown at
left.
c Push [Y] or [Z] to select the scan resume condi-
tion.
• See item e at left for scan resume condition details.
v Push [
A(MW)] to exit set mode.
CLR
NOTE:
Set mode cannot be accessed when memory names are
displayed. To set the scan resume condition, return to fre-
quency indication by pushing [MONI(ANM)] on the front
panel for 1 sec., or push [FUNC] then [
133V) to cancel the channel name indication, then set as
described on this page.
SCAN OPERATION
C(T-OFF)] several
ENT
1(ANM)] (HM-
MONI
7
7
42