Programming A Memory Channel Via The Microphone - Icom IC-V8000 Instruction Manual

D Programming a memory channel via the microphone
The microphone can also be used to program mem-
MW
ory channels.
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data
(e.g. offset frequency, duplex direction, sub-
audible tone encoder ON/OFF and its frequency)
sary.
x Push [FUNC] then [
A(MW)] momentarily.
CLR
c Select the memory channel to be programmed.
➥ Push [Y] or [Z] to select the memory channel
meral input cannot be used)
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.
Push
Push
, if neces-
(direct nu-
.
Push
Push then
v Push [FUNC] then [
CLR
➥ 3 beeps may sound and the VFO contents (including
the subaudible tone frequency, etc.) are programmed.
➥ Memory channel number increases when continuing to
push [ A(MW)] after programming.
CLR
Push then
➠
1 sec. and continue to push
"
"
Beep
"
Beep
"
Beep
"
MEMORY OPERATION
A(MW)] for 1 sec. to program.
momentarily.
5
5
26