2.2.9 Panel Switch Commands
ESC c 5 n
support model
[Function]
Enabling/disabling the panel switches
[Code]
<1B>H<63>H<35>H<n>
[Range]
0≦n≦255
[Outline]
[The specification which is common to the model]
Enabling/disabling the FEED switch.
• "n" is valid only for the lowest bit (n0).
• Control by the lowest bit (n0) is shown as follows:
[Caution]
• When the FEED switch is disabled with this command, the paper cannot be fed by operating the
FEED switch.
• While switch operation is waited at the execution of macro, the FEED switch is always enabled
regardless of the setting of this command but no paper feed operation is carried out.
[Default]
n=0
[Sample Program]
LPRINT CHR$(&H1B);"c5";CHR$(0); ・・・・・ When enabling the FEED switch
LPRINT CHR$(&H1B);"c5";CHR$(1); ・・・・・ When disabling the FEED switch
CT-S280
CT-S300
PMU2XXX
n0
0
FEED switch (LF-SW signal) valid
1
FEED switch (LF-SW signal) invalid
CT-S2000
CT-S4000
Condition
- 97 -
BD2-2220
CT-S310