Gs I N - Citizen BD2-2220 Command Reference Manual

GS I n

support model
[Function] Sending the printer ID
[Code]
<1D>H<49>H<n>
CT-S280/BD2-2220
[Range]
1≦n≦3、49≦n≦51、65≦n≦67、n＝69、112
CT-S300/CT-S2000/CT-S4000/CT-S310/PMU2XXX
1≦n≦4、49≦n≦52、65≦n≦67、n＝69、112
[Outline] [The specification which depend on the model]
Sends the specified printer ID.
[Caution] • Under DTR/DSR control, the printer sends the printer ID after verifying that the host is ready to
receive.
• If the host is not ready to receive, the printer waits for the host to become ready to receive.
• Under XON/XOFF control, the printer sends the printer ID without checking whether or not the
host is ready to receive.
• Because this command is executed when data is mapped in the receive buffer, there may be a
delay between command receiving and printer ID sending depending on the condition of the
receive buffer.
• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate between the printer
ID due to this command and the status due to ASB.
CT-S300/CT-S2000/CT-S4000/CT-S310/PMU2XXX
• Sending the Black mark length is valid only when Black mark paper is selected.
CT-S280 CT-S300
PMU2XXX
CT-S2000 CT-S4000
- 228 -
BD2-2220 CT-S310