Gs V 0 M Xl Xh Yl Yh D1 - Citizen BD2-2220 Command Reference Manual

GS v 0 m xL xH yL yH d1 ... dk
support model
[Function] Printing of raster bit image
[Code]
<1D>H<76>H<30>H<m><xL><xH><yL><yH>〔<d>〕k
[Range] 0≦m≦3、48≦m≦51、0≦xL≦255、0≦xH≦255、
0≦yL≦255、0≦yH≦8、0≦d≦255、
k=(xL+xH×256)×(yL+yH×256) ,however,k≠0
[Outline] [The specification which is common to the model]
Prints raster bit images in mode "m".
m
0,48 NORMAL MODE
1,49 DOUBLE WIDTH MODE
2,50 DOUBLE HEIGHT MODE
3,51 QUADRUPLE SIZE MODE
• xL, xH specify the number of data in horizontal direction of the bit image to (xL+xH×256) bytes.
• yL, yH specify the number of data in vertical direction of the bit image to (yL+yH×256) bytes.
[Caution] [The specification which is common to the model]
• Any of the print modes (character size, emphasis, double strike, inverting, underlining,
back-to-white reversing, etc.) does not affect the raster bit image.
• If the print area specified by GS L and GS W is narrower than a minimum width, the print area for
that line only is extended to the minimum width. The minimum width is one dot in NORMAL
MODE (m = 0, 48) and DOUBLE HEIGHT MODE (m = 2, 50), and 2 dots in DOUBLE WIDTH
MODE (m = 1, 49) and QUADRUPLE SIZE MODE(m = 3, 51).
• Any part of data that is out of the print area is only read and discarded in units of dot.
• The print start position can arbitrarily be specified with HT (horizontal tab), ESC $ (specifying
absolute position), ESC ＼ (specifying relative positions), and GS L (setting left margins). Note that
if the print start position is not a multiple of 8, the printing speed may decrease.
• The setting of ESC a (aligning characters) are also valid for the raster bit image.
• If this command is executed during macro definition, the macro definition is suspended, and the
processing of the command starts. The macro is left undefined.
• "d" denotes defined data. Dots to be printed are specified as "1", and those not to be printed as
"0".
[The specification which depend on the model]
CT-S280/CT-S300/BD2-2220/CT-S310/PMU2XXX
• Valid only when no print data is present in the print buffer at the selection of STANDARD
MODE.
CT-S2000/CT-S4000
• Valid only when no print data is present in the print buffer (at the top of a line).
CT-S280 CT-S300
PMU2XXX
Mode Name
CT-S2000 CT-S4000
Dot Density in
Vertical Direction
203dpi
203dpi
101dpi
101dpi
- 79 -
BD2-2220 CT-S310
Dot Density in
Horizontal Direction
203dpi
101dpi
203dpi
101dpi