Gs P X Y - Citizen BD2-2220 Command Reference Manual

GS P x y

support model
[Function] Specifying the basic calculation pitch
[Code]
<1D>H<50>H<x><y>
[Range] 0≦x≦255、0≦y≦255
[Outline] [The specification which depend on the model]
• This command sets the horizontal basic calculation pitch to approx. 25.4/x mm (1/x inches), and
the vertical basic calculation pitch to approx. 25.4/y mm (1/y inches).
• If x = 0, the horizontal basic calculation pitch is reverted to the default value.
• If y = 0, the vertical basic calculation pitch is reverted to the default value.
[Caution] • The horizontal direction is defined as the direction perpendicular to the paper feed, and the
vertical direction is defined as the paper feed direction.
• In STANDARD MODE, the following parameters are used regardless of the character orientation
(e.g. inverted or 90°-right-turned).
• In PAGE MODE, the parameters used depend on the character orientation, as follows:
• This command does not affect any other values that are already set.
• If calculations made in combination with another command generate fractions, the fractions are
corrected with the minimum pitch of the mechanism, and the remainder is omitted.
[Default] x=203、y=360
[See Also] Appendix 5.1 "Explanation on PAGE MODE"
ESC SP､ESC $、ESC 3、ESC J、ESC W、ESC ＼、GS $、GS L、GS W
CT-S280 CT-S300
PMU2XXX
(1) Commands using x: ESC SP, ESC $, ESC ＼, FS S, GS L, GS W
(2) Commands using y: ESC 3, ESC J
(1) If the start point specified by ESC T is the top left or bottom right (The characters are
mapped in the direction perpendicular to the paper feed):
• Commands using x: ESC SP, ESC $, ESC W, ESC ＼, FS S
• Commands using y: ESC 3, ESC J, ESC W, GS $, GS ＼
(2) If the start point specified by ESC T is the top right or bottom left (The characters are
mapped in the paper feed direction):
• Commands using x: ESC 3, ESC J, ESC W, GS $, GS ＼
• Commands using y: ESC SP, ESC $, ESC W, ESC ＼, FS S
CT-S2000 CT-S4000
- 235 -
BD2-2220 CT-S310