I Scan Edges Programming - Icom IC-91A Instruction Manual

9
SCAN OPERATION

I Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
q Push [VFO] to select VFO mode.
w Set the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the desired frequency with [DIAL].
➥ Set other data
, if desired.
squelch, etc.)
ePush and hold [S.MW](MR) for 1 sec. to enter the select
memory write mode.
• 1 short and 1 long beeps sound.
• "µ µ
" indicator blinks.
rRotate [DIAL] to select the desired programmed scan
edge channel from 00A to 24A.
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
Push
145 300
76
(e.g. offset frequency, duplex direction, tone
for 1 sec.
Rotate [DIAL]
146 010
r
µ 001
t Push and hold [S.MW](MR) for 1 sec.
• 3 beeps sound
• The other scan edge channel "B," 00B to 24B, is automatically
selected when continuing to push [S.MW](MR) after program-
ming.
yTo program a frequency for the other pair of scan edges,
00B to 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
Push for 1 sec.
r 145 300
µ 03A
.
[DIAL]
145 300
03A