I Memory Bank Scan - Icom IC-91A Instruction Manual

9
SCAN OPERATION

I Memory bank scan

IMPORTANT!: To perform memory bank scan, 2 or more
bank channels MUST be programmed, otherwise the scan
will not start.
qPush [S.MW](MR) several times to select memory bank
mode.
w Set the squelch level.
eWhile pushing and holding [SCAN](2), rotate [DIAL] to se-
lect the desired scanning type.
• "ALL" for all bank scan; "BANK-LINK" for bank link scan or
"BANK-x" for bank scan (x= A to Z; programmed bank groups
are only displayed.), "DUP" (appears only when duplex opera-
tion is set) for duplex scan.
78
[DIAL] • All bank scan selection
146 010
µ
148 800
• Bank link scan selection
µ
148 800
• Bank scan selection
µ
Selectable between "A" to "Z"
if programmed.
r Release [SCAN](2) to start the selected scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
t To stop the scan, push [VFO].
• During all bank/bank link scan • During bank scan
148 800
The bank-link setting can be changed in scan set mode.
See page 97 for details.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
A01 A01
A01 A01
A01 A01
148 800
888
µ
A88
µ