Memory Operation; I General Description; I Memory Channel Selection - Icom IC-2720H Instruction Manual

5

MEMORY OPERATION

I General description

The transceiver has 212 memory channels including 10 scan
edge memory channels (5 pairs), and 2 call channels. Each of
these channels can be individually programmed with operating
frequency (pgs. 11–13), duplex direction (p. 23) and offset
(p. 27), subaudible tone encoder or tone squelch and its tone
frequency (pgs. 23, 25, 52, 53) and skip information* (p. 44).
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.

I Memory channel selection

D Using the tuning dial
Push [M/CALL•MW] to select
memory mode.
MAIN
T X
"!" appears
29
*except for scan edge memory channels.
q Push the desired band's
[M/CALL(MW)]
times to select memory
mode.
• "M" indicator appears
w Rotate the same band's
[DIAL] to select the de-
sired memory channel.
• Programmed
channels only can be se-
lected.
M
D Using the [Y]/[Z] keys
z Push [BAND] to select the desired band as
MR/CALL
x Push [MR/CALL] to select memory mode.
c Push [Y] or [Z] to select and set the desired
Y/Z
D Using the keypad
z Push [BAND] to select the desired band as
MR/CALL
x Push [MR/CALL] to select memory mode.
c Push [
Y/Z
several
v Push 3 appropriate digit keys to input a chan-
memory
the main band.
memory channel.
• Pushing [Y]/[Z] for 1 sec. activates a scan.
• If scan is activated, push [Y]/[Z] again or push
[ A(MW)] to stop it.
CLR
the main band.
C(T-OFF)] to activate the keypad
ENT
for numeral input.
nel number.
• Blank channel can be selected.
• Push only 1 appropriate digit key, [
[ 2(T-SCAN)],
SCAN
[ 4(DTCS)] or [ 5(DTCSS)] then push
HIGH MID
[M M (TONE-1)] or [
#(16KEY-L)] to select scan
Z
SQL
edge channels. "M M " and "#" can be used for "A"
and "b" respectively.
1(BANK)],
MONI
[ 3(PTT-M)],
PRIO