I Offset Frequency - Icom IC-2720H Instruction Manual

4
REPEATER OPERATION

I Offset frequency

When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
qPush [MAIN•BAND] to select the desired band (left or right)
as the main band.
• Push [MAIN•BAND] for 1 sec. then rotate the [DIAL] to select the
desired frequency band if necessary.
wSelect the desired mode/channel you wish to set the offset
frequency to, such as VFO mode or memory/call channel.
• The offset frequency can be independently programmed into
each mode or channel.
e Push [SET•
] to enter set mode.
rPush [SET•
] or [LOW•PRIO] until "DUP" and offset fre-
quency appear.
DUP
MAIN
T X
M
"DUP" and offset frequency appear
tRotate the main band's [DIAL] to set the desired offset fre-
quency.
y Push [TONE•DTMF] to exit set mode.
27
SET MODE
USING
[LOW•PRIO] [SET• ]
z Push [BAND] to select the desired band (left or
SET
right) as the main band.
B
• Enter the desired frequency via the keypad if neces-
sary.
x Select the desired mode/channel you wish to
set the offset frequency to, such as VFO mode
or memory/call channel.
• The offset frequency can be independently pro-
grammed into each mode or channel.
c Push [
B(D-OFF)] to enter set mode.
SET
v Push [
B(D-OFF)] or [
SET
"DUP" and offset frequency appear.
Push
b Push [Y] or [Z] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
n Push [
A(MW)] to exit set mode.
CLR
NOTE: The offset frequency can be set in a memory/call
channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
C(T-OFF)] until
ENT
DUP
MAIN
T X
M