Icom IC-2720H Instruction Manual page 75

D D DTCS polarity
Sets DTCS polarities for transmission and reception from
"nn," "nr," "rn" and "rr."
DTCS
MAIN
T X
M
• Transmit : normal
Receive : normal
(default)
D D Offset frequency
Sets the duplex offset frequency within 0 to 20 MHz range.
During duplex (repeater) operation, transmit frequency shifts
the set frequency.
(default value may differ depending on operating
frequency band and versions)
MAIN DUP
T X
D D Tuning step
Selects tuning step from 5, 10, 12.5, 15, 20, 25, 30 and
50 kHz for [DIAL] or [Y]/[Z] operation.
depending on operating frequency band and versions)
MAIN
T X
(default: nn)
DTCS
MAIN
T X
M
• Transmit : normal
Receive : reverse
M
(default value may differ
M
OTHER FUNCTIONS
D D Scan resume timer
Selects scan resume timer from SCT-15 (default), SCT-10,
SCT-5 and SCP-2.
• SCT-15/10/5 : Scan pauses for 15/10/5 sec., then re-
sumes.
• SCP-2 : Pause on a signal until signal disap-
pears, then resumes 2 sec. after the sig-
nal disappears.
MAIN
T X
M
D D Channel skip setting
Sets channel skip setting from ON and OFF for memory skip
scan operation.
This item appears when set mode is accessed from memory
mode only.
MAIN
T X
M
• Default setting
11
MAIN
T X
M
MAIN
T X
M
SKIP
• "~" appears
when set to "On."
11
58