Table of Contents
Advertisement
6-4
S
ERVICE
REPLACING REHEAT HEATERS
For access to these heaters:
1. Turn off power.
2. Remove shelves, wire racks, bottom display
pans and back panels.
3. Disconnect heater from wiring harness.
4. Remove screws and clips holding heater in
position. Be sure to save the attachment clips
for the new heater.
5. Remove and replace heater.
6. Reconnect heater to wiring harness.
7. Replace clips and screws. Turn power on.
8. Verify that new heater is working properly.
9. Replace back panels, wire racks, display pans
and shelves.
P/N 424382A
Clip and screw
WARNING
!
Always disconnect the electrical power at the
main disconnect when servicing or replacing
any electrical component. This includes, but
is not limited to, such items as fans, heaters,
thermostats and lights.
NOTE: Because the reheat heater is 120V, it will
be energized at all times, including defrost.
Connection
Advertisement
Table of Contents
