Heater Mounting; Joining Instructions - Hussmann Impact F2XLG Installation And Operation Manual

P/N 424382A
WARNING
!
Make certain defrost heaters are secured
and do not touch bottom liner.
Make certain mounting plates for reheat
heaters are horizontal across air flow
and reheat heaters are secure.

HEATER MOUNTING

The F2 models use two types of heater that can
vibrate loose during shipment. Verify that each
defrost heater is secure in its bracket and does not
touch the bottom liner. Also verify that each reheat
heater is secure in its brackets and the mounting
plate horizontal across the air flow. Refer to
Section 6 – Service for location and access.

JOINING INSTRUCTIONS

Sectional construction means that two or more
merchandisers may be joined in line yielding one
long continuous display requiring only one pair of
ends.
A
LL JOINTS MUST BE AIR
FORMATION OF ICE OR CONDENSATION
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
-
TIGHT TO PREVENT
.
Prepare Case
1. Check to be sure that merchandisers are level
and that the factory-installed nut retainers and
alignment pins are in place. Locate Joint Kit
and compare contents to parts list.
2. Remove shelves (if installed), display racks,
pans, front shelf supports and front air grilles
from the right end.
3. Remove the rear panel from the right end. To
remove a panel, lift it up from its bottom edge
and out. No tools are required.
Apply Gaskets
5
/
1. Apply 1 in. (31 mm) gasket in the horizon-
8
tal recess across the bottom and up the front
of the merchandiser as shown. Gasket should
cover slots.
5
/
2. Apply the 1 in. (31 mm) gasket to cover
8
foam-to-metal gap at rear of case and across
the top as shown. Be sure to overlap gaskets
as shown on next page. Check to be sure that
there are no gaps between gasket and mer-
chandiser.
Fasten Cases
1. Move the second merchandiser into position
against the first. Match the alignment pins
with the corresponding holes.
2. Fasten fronts together using cap screws, flat
washers, lock washers and nuts. Tighten only
until front panels touch. Do not tighten fully.
3. Use the cap screws, flat washers and lock
washers provided in the joint kit to draw
merchandisers together at rear. Do not
tighten fully.
4. Draw canopies together using cap screws, flat
washers, lock washers and nuts. Tighten only
until canopies touch.
5. Tighten joints in the order shown (A, B, C, D)
until gaskets are compressed, and cases join
smoothly.
Frozen Meat and Seafood
1-3