Table of Contents
Advertisement
1-6
I
NSTALLATION
4. Install lower bumper starter and full length
lower bumpers by simply pushing them into
place. There are no internal joint trims on
lower bumpers.
5. Return to left end of line up and position
starter section of glass trim.
6. Apply field- supplied silicone sealant to under-
side of short glass trim. Push short glass trim
section down over glass and toward end of
case. Press firmly in place.
7. Install full length glass trims using the same
procedures. Continue installing glass trims
along the length of the line up. Do NOT install
last section at this time.
Note: If part of a section of plastic glass trim
becomes loose, remove that section and re-install.
Trying to re-install only the popped part may not
secure the trim, and may damage the trim.
8. Once all except the last sections of upper
bumper and glass trim have been installed,
refrigerate the case line up for at least six (6)
hours. The last sections of upper bumper
and glass trim should be kept inside a
refrigerated case or cooler during this time
to allow the bumpers and trim to contract.
P/N 424382A
Starter
Bumper
Retainer
Internal Joint Trims
Merchandiser
Joint
Full Length
Bumper
9. Go to right end of case line up and tap glass
trim and bumpers to close any gaps.
10. Measure and cut last section of bumpers and
glass trim. Use a miter box and fine-tooth saw
to cut last bumpers and glass trim to length.
Install the last sections.
Apply field-supplied silicone sealant to under-
side of end trim and press firmly in place.
Miter Box
Note: To join unlike fixtures, or like fixtures
operating at different temperatures, a 1
(38 mm) partition kit is required. Instructions for
installing this partition are included with the kit.
Bumper
1
/
in.
2
Advertisement
Table of Contents
