Installation
Electrical Shock Hazard
Before carrying out any work on the electrical section of the appliance,
it must be disconnected from the mains electricity supply.
Connection to a good ground wiring system is absolutely essential
and mandatory.
Alterations to the domestic wiring system must only be made by a
qualified electrician
Failure to follow this advice may result in electrical shock or death.
Fire Hazard
Do not use adapters, reducers, or branching devices to connect this
appliance to the mains power supply.
Failure to follow this advice may result in overheating, burning, or fire.
Cut Hazard
Take care – some edges are sharp.
Failure to use caution could result in injury or cuts.
IMPORTANT SAFETY INSTRUCTIONS!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
Save these instructions for the local inspectors use.
●
Please make this information available to the person installing the appliance – doing
●
so could reduce your installation costs.
This oven is to be installed and connected to the electricity supply only by an
●
authorized person.
IMPORTANT!
SAVE THESE INSTRUCTIONS
12 |
STEAM OVEN INSTALLATION GUIDE
1
WARNING!
WARNING!
WARNING!
SAFETY AND WARNINGS
If the installation requires alterations to the domestic electrical system, call a qualified
●
electrician. The electrician should also check that the socket cable section is suitable
for the electricity drawn by the oven.
The oven must be grounded.
●
Installation must comply with your local building and electricity regulations.
●
This appliance must be installed and connected to the mains power supply only by a
●
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its
●
service agent or similarly qualified person in order to avoid a hazard.
A circuit breaker is recommended.
●
Do not use adaptors, reducers or branching devices to connect the oven to the mains
●
electricity supply, as they can cause overheating and burning.
Make sure the cavity is completely sealed with no gaps. This is to ensure the oven
●
cooling system functions correctly.
Do not allow children and animals to stop or linger near the appliance when it is pulled
●
out of the cabinet.
Electrical requirements
Connect oven with copper wire only.
●
Do not cut the conduit.
●
A U.L. listed conduit connector must be provided at the junction box.
●
Do not ground to a gas pipe.
●
Do not have a fuse in the grounding or neutral circuit.
●
Fuse both sides of the line.
●
A time delay fuse or circuit breaker is recommended. If using a time delay fuse, then
●
fuse both sides of the line.
Flexible armored cable from the appliance should be connected directly
●
to the junction box.
Connect directly to the fused disconnect (or circuit breaker box) through flexible,
●
armored or non-metallic sheathed, copper cable (with grounding wire).
If codes permit and a separate grounding wire is used, it is recommended that a
●
qualified electrician determine that the grounding path and wire gauge are in
accordance with local codes.