Installing The Equipment; Installing The Mr-J3-D01 Extension - Mitsubishi Electric MR-J3-T Quick Start Manual

Installing the Equipment

2 Installing the Equipment
The pro ce dure for the phys i cal instal la tion of the MR-J3-T series hard ware is exactly the same
as for the MR-J3-A and MR-J3-B mod els. The dimen sions of the MR-J3-T series ampli fi ers are
iden ti cal to those of the match ing mod els of the MR-J3-A and MR-J3-B series.
NOTE Plea se con sult the in struc ti on ma nu al for de tai led in stal la ti on in struc tions.
2.1

Installing the MR-J3-D01 Extension

Pro ce dure:
Remove the cover of the CN7 con nec tor on the right side of the MR-J3-T hous ing.
Fig. 2-1:
Po si ti on the MR-J3-D01 ex ten si on over the up per and lo wer moun ting points 1 on the ser -
vo am pli fier, then press the ex ten si on into pla ce so that the lugs click into po si ti on in the up -
per and lo wer moun ting points 2. This also con nects the ex ten si on to the am pli fier via con -
nec tor CN7 on the amplifier.
Fas ten the ex ten sion se curely to the servo am pli fier with the M4 screw (in cluded) as
shown in Fig. 2-2.
MR-J3-T
Up per mount ing
point 2
Co ver for CN7
con nec tor
Lo wer moun ting
point 2
Fix ing points of the ex ten sion MR-J3-D01
Installing the MR-J3-D01 Extension
Up per mount ing
point 1
Lo wer mount ing
point 1
2 - 3