Outline; System Configuration; Supported Got; Necessary Equipment - Mitsubishi Electric MELSERVO-J5 Series Sample Screen Manual

1. OUTLINE

This manual explains the sample screens for GOT2000 connected to MR-J5-G servo amplifier via a MELSEC iQ-R
series programmable controller. The sample screens allow changing parameters and monitoring the values, as well
as performing machine diagnosis and test operation.
In the sample screens, one axis is monitored in each screen. Monitor target can be switched by changing the target
axis in a screen. Up to 768 monitoring target axes can be registered. The motion mode and the simple motion mode
of motion modules are supported.
In addition, by changing the settings, connection via a MELSEC iQ-F series programmable controller and Ethernet
connection with servo amplifiers is also available. For details, refer to "Connection via a MELSEC iQ-F series
programmable controller (CC-Link IE TSN connection)" and "Connection over Ethernet" in "2.3 Connection
Configuration".

2. SYSTEM CONFIGURATION

2.1 Supported GOT

The sample screens are available for the following GOTs.
・GT27 model
・GT25 model
* The sample screens are created in accordance with GT27**-V (640×480).
For how to change the GOT model, refer to "GT Designer3 (GOT2000) Screen Design Manual".

2.2 Necessary Equipment

Necessary equipment to use the sample screens is as follows.
Equipment
PLC (MELSEC iQ-R)
Motion module
(RD78G or RD78GH)
Servo amplifier
(MR-J5-G, MR-J5W 2 -G, MR-J5W3-G)
Motor
Ethernet cable
Motor cable
SD card
B attery (GT11-50BAT)
Application
Equipment for system configuration
Recipe function (file save)
Document display function
Clock data
Recipe function
(Saves in the SRAM user area)
8/128
Remarks
-
-
-
-
-
-
-
I ncluded in a GOT as
standard.
BCN-P5999-1471-3c