Table of Contents
Advertisement
Freestanding cube + plinth installation cont.
4. Fix fire base plate to plinth
Unpack the fire, refer p.12 for more information. Remove the fire base plate and fix to the top of the
plinth assembly using the stiffening rails as shown. Fit the second flexi pipe supplied with the fire.
5. Check aeration setting
Check that the correct aeration shutter plates are fitted, refer p.14. It is still possible to change the
aeration setting once the fire is installed, however it is much easier to do this beforehand.
6. Fit the fire to the plinth
Lift the fire onto the plinth and feed the gas supply tube through the hole in the back corner. The
fire needs to be set approximately 20 mm back from the plinth, then slip forward so the bottom
edge of the fire back panel sits under the back edge of the fire mounting plate.
Fix in place with 2 x M5 screws through the front edge of the fire, circled below.
20 | Novo freestanding installation guide:13992-A 01-22
Fire mounting plate
Fire back
panel
Advertisement
Table of Contents
