Plug And Play - Juniper Day One+ JSA7800 Manual

Now that the JSA7800 is powered on, let's do some initial configuration to get it up and running on the network.

Plug and Play

The JSA7800 ships with factory-default settings that enable plug-and-play operation. These settings load as soon as you
power on the switch.
Connect the Management Device
1. Connect a laptop or desktop PC to the DB-9 serial COM port on the back panel.
NOTE: If your laptop or PC does not have a DB-9 plug connector pin and you want to connect your laptop
or PC directly to the JSA7800, use a combination of a USB to DB-9 plug adapter and a DB-9 F/F cable (not
provided).
2. Verify that the serial port settings for your laptop or desktop PC are set to the default:
Bits per second = 9600
Stop bits =1
Data bits = 8
Parity = None
9