Table of Contents
Advertisement
LOG PLACEMENT FOR DVCD36 FIREPLACES
This fireplace is supplied with a set of six ceramic fiber logs. Do
not handle these logs with your bare hands! Always wear gloves
to prevent skin irritation from ceramic fibers. After handling the
logs, wash your hands gently with soap and water to remove any
trace of fibers.
Accessing the Interior of the Fireplace
1.
Remove the barrier screen and glass door. See Barrier
Screen and Glass Door Removal, page 80.
The positioning of the logs is critical to the safe and clean
operation of this fireplace. Sooting and other problems may
result if the logs are not properly and firmly positioned in the
fireplace. Please refer to Figure 70 and the following WARNING
when completing log placement instructions. For step by step log
placement instructions, see pages 51 - 57.
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
fireplace may result in property damage or personal injury.
A
C
A
Page 50
WARNING
F
D
C
B
EMBER MATERIAL PLACEMENT
(SHADED AREA ONLY)
Figure 70
D
E
F
B
Figure 71
Decorative Material Placement
1.
Position all of the logs before placing the decorative
materials.
2.
Place the decorative rocks in front of the grates and at the
sides of the main burner pan.
3.
Carefully separate the ember material into small amounts
(no larger than
"dime-size"
4.
Place the ember material pieces on the front burner port
area. See Figure 72.
a.
Fluffed up pieces of ember material one layer thick
will produce the best ember glow. Do not place more
than one layer of ember material onto the burner ports.
Excess ember material will decrease the ember glow
effect.
b.
Save any remaining ember material for future
applications (as needed).
Attention: Do not place decorative rocks on logs or burner. The
decorative rocks should only be placed on the fireplace floor.
E
EMBER MATERIAL PLACEMENT
(SHADED AREA ONLY)
pieces).
Figure 72
38712-4-0920
Advertisement
Table of Contents
Troubleshooting
