Table of Contents
Advertisement
Before you begin: Do not, handle these logs with your
bare hands! Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently with soap and
water.
All Logs
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may
appliance.
Warning: Failure to position the parts in accordance
approved with this appliance may result in property
damage or personal injury.
PROPER INSTALLATION SEQUENCE:
pan.
burner pan.
burner pan.
4. Compare the completed log installation with the
appropriate photo from page 25. Review previous steps
to make any necessary adjustments.
5. Log placement is completed.
6. Attach log placement plate to cable holding lighting
instructions for future reference.
Attention: Do not use Figure 26 to order replacement logs.
Refer to Page 40 Parts List and Parts View to order logs for
your appropriate model number.
an authorized distributor. Application of excess loose material
heater.
Rock wool can be added to burners for a glowing ember
locations shown on Page 25. Replacement of loose material
embers) may adversely affect performance of the heater.
Page 24
VFP20IN LOG PLACEMENT
WARNING: All previously applied loose material must be
removed prior to reapplication.
Note: A single layer of embers is to be used when applying
production embers) to the burner.
1
2
The following WARNING applies when log set is installed
onto an unvented gas burner assembly.
propane) gas. Field conversion is not permitted.
3
26497-6-0511
Advertisement
Table of Contents
