Table of Contents
Advertisement
2-2. Connecting the printer to your Computer
STP-103P
You need an appropriate parallel interface cable to connect your computer to the
printer's built-in interface.
1. Make sure that both the printer and computer are turned off :
then plug the cable connector securely into the printer's interface connector.
2. Tighten the screws on both sides of the cable connector.
3. Plug the other end of the cable into the computer.
25 Pin Female Type
12
Chapter 3. Installing the Paper Roll
Use a paper roll that matches the specifications.
NOTE
The printer must be turned off before installing the paper roll.
1. Open the printer cover and remove the used paper roll core if there is one.
2. Insert the paper roll as shown below.
3. Pull out the paper roll until the paper comes out from the top of the printer. Then
close the printer cover.
4. Turn on the Printer.
13
Advertisement
Table of Contents
