Installing Or Replacing The Paper Roll; Setting The Dip Switches - Samsung SRP - 770 Operator's Manual

5. Installing or Replacing the Paper Roll

① Open Cover
③ Install Roll
④ Close Guides to the Width of the paper
② Open Guides
⑤ Close Cover
8

6. Setting The Dip Switches

6-1. Setting the Dip Switches
The Dip Switches are located on the bottom of the printer. The Dip Switches are used to
set the Printer to perform various functions. Follow these steps when changing Dip
Switches setting :
1. Turn the printer power switch off.
2. Remove the screw on the bottom of the printer and open the bracket.
3. Flip the Dip Switches using tweezers or another narrow-ended tool. Switches are
off when up and on when down in the Figure below.
4. The new setting takes effect when you turn on the printer.
Note : Always change Dip Switch settings only when the printer is turned off.
6-2. Functions of Dip Switches
6-2-1. Dip S/W 1
Details
NO Functions
2 1 Speed
Off Off 2.5 ips
Speed
1,2 Off On 3.0 ips
Selection
On Off 4.0 ips
On On 5.0 ips
4 3 Density
Off Off 0(Low)
Density
3,4
Off On 7
Selection
On Off 13
On On 20(High)
5,6, Developer
Default --- off
7 Mode
Position Off Move to Cutting Position
8
Selection On Move to top of next page
6-2-2. Dip S/W 2
No Functions Details
2 1 Baud Rate
Off Off 9,600 bps
Baud
1,2 Off On 19,200 bps
Rate
On Off 57,600 bps
On On 115,200 bps
Flow Off Xon/Xoff
3
Control
On RTS/CTS
Interface Off Serial & Parallel
4
Selection On Serial & USB
Developer
5~8 Default --- off
Mode
9