Table of Contents
Advertisement
BHT-604B
"3: ITF": Minimum number of digits to be read for ITF
"4: STF": Minimum number of digits to be read for STF
"5: CODABAR": Minimum number of digits to be read for Codabar
Set minimum number of digits for the code to be read.
Press [ ] to decrease the setting value and [ ] to increase the setting value.
ITF entry range:
STF entry range:
Codabar entry range:
Setting a small number of digits increases the frequency of missing digits when reading or incorrectly
reading depending on how barcodes are read or the quality of barcodes. On the other hand, setting a
large number will decrease the possibility of such errors.
[5] Setting the communication environment
The communication environment settings following system initialization are follows.
Do not change these settings unless necessary.
Interface port
Communication protocol
Infrared interface port
TRANSMIT SPEED
PROTOCOL
Direct-connect interface port
TRANSMIT SPEED
PARITY BIT
DATA BIT
STOP BIT
PROTOCOL
68
2 - 20
(Default: 4)
1 - 20
(Default: 3)
3 - 20
(Default: 4)
Item
Optical (infrared interface port)
Ymodem protocol
Baud rate
115200 bps
Protocol options
SERIAL No.:
H. PARITY:
LINKUP TIME:
FIELD SPACE:
115200 bps
Baud rate
(Vertical parity)
None
(Character length)
8 bits
(Stop bit length)
1 bit
SERIAL No.:
(Protocol options)
H. PARITY:
LINKUP TIME:
FIELD SPACE:
Default
ON (
Adds serial numbers to data
)
blocks.
ON (
)
Adds horizontal parity.
30
seconds
Ignore (
Trim
)
ON (
Adds serial numbers to data
blocks.
)
ON (
Adds horizontal parity.
)
30
seconds
Ignore (
)
Trim
Advertisement
Chapters
Table of Contents
