Volvo Penta D3 Operator's Manual page 39

F
P0012501
10
9
6
TRIM
Assist
7
LOW
SPEED
8
3
47705992 05-2015 © AB VOLVO PENTA
N
R
1 2
CRUISE
STATION
CONTROL
SINGLE
THROTTLE
LEVER
ONLY
4
5
P0013213
Controls
This section describes the controls Volvo Penta sells
for your engine. Contact your dealer if your boat is
equipped with controls other than those described
here, and you feel uncertain about their function.
A single-lever control operates both gearshift and
throttle functions with the same lever.
The engine can only be started with the control lever
in the neutral position.
N = Neutral position. Reverse gear/drive disengage-
dand engine at idle.
F = Reverse gear/drive engaged for forward motion.
R = Reverse gear/drive engaged for rearward
motion.
T = Engine rpm control (throttle).
Engine and drive features are controlled with push but-
tons on the control. What buttons and functions avail-
able is depending on the installation.
1 STATION
The button lamp is lit if the helm station is active and
lit. Refer to Helm Stations page 57 for further
information.
2 CRUISE CONTROL (optional)
Switch on cruise control by pressing the button.
Fine tune the locked engine speed by increasing (+)
or reducing (-) engine rpm with the button at the
other side of the control.
3 LOW SPEED (optional)
See Optional page 42 for information.
4 THROTTLE ONLY
Disconnects the shift function so that the control
lever only affects engine speed; refer to "Disengag-
ing shift function" in this chapter for further informa-
tion.
5 SINGLE LEVER (optional)
Switch on the single-lever function by pressing the
button. The lever that is moved from its position first
becomes the control lever for both engines. The
other control lever has no function as long as the
single-lever function is activated. The button lamp
lights up to show that the function is active. Exit the
single-lever function by pressing the button again.
Instruments and Controls
37