Volvo Penta D3 Operator's Manual page 107

2
P0003080
47705992 05-2015 © AB VOLVO PENTA
Reverse Gear, Oil och Filter Change
1 Clean around the cap (2) so that there is no risk of
2 Undo the Allen bolt (1) with a 6mm Allen key.
3 Remove the filter (3).
4 Use an oil drain pump to pump out the oil from the
1
5 Measure out the correct quantity of oil and fill the
6 Install the new filter (3) in the filter housing.
7 Install the cover. Tightening torque: 5-8 Nm
8 Put the control lever in neutral. Start the engine and
9 Stop the engine and check the oil level. Top up as
3
4
Propeller Shaft Sealing, Check
If the boat is fitted with a Volvo Penta propeller shaft,
the propeller shaft seals must be lubricated before
launch and purged directly after launching.
Purge the glands by pressing them together, at the
same time as they are pressed down onto the shaft.
The press approximately 1 cm³ of water resistant
grease into the seal.
dirt falling into the filter housing.
Remove the cover (2). Change the O-rings in the
cap; lubricate the new ones.
oil filter housing. Connect the hose to the suction
tube (4) in the bottom of the housing. Suction hose
maximum external diameter is 16 mm.
reverse gear via the oil filter housing. Refer to the
Technical Data page 133 section for oil grade and
quantity.
IMPORTANT!
Never over-fill the reverse gear. The oil level must
always be within the recommended range.
run it at 1500 rpm for a few minutes so that the
reverse gear oil cooler fills with oil.
needed
Maintenance
105