Minimum Configuration Requirements For Snmp/Telnet Access; Interface; Ip Address; Subnet Mask - ADTRAN DSU IV ESP User Manual

Minimum Configuration Requirements for SNMP/Telnet Access

The following options are the minimum configuration
requirements for establishing SNMP or Telnet access. Once these
options are configured, the remaining options may be configured
using SNMP/Telnet. See the menu tree in Figure 10-1 on page 10-2
for the front panel menu path to these options.

Interface

Select SLIP Control, PPP Control, or Ethernet LAN as the DSU IV
interface type. The ESP ethernet card must be installed for the
Ethernet LAN selection.

IP Address

Enter the DSU IV ESP IP address.

Subnet Mask

Enter the subnet number. This address is available from the
network administrator.

Gateway IP Address (if required)

Enter the Gateway node IP address. This address is necessary only
if the DSU IV and the network manager are connected through a
Gateway node. This address is available from the network
administrator.

Special Features of this Application

Customize the SNMP/Telnet application using the following DSU
IV ESP features:
•
•
Configure these options through the Management portion of the
Configuration menu. See Chapter 10, Management Functions on
page 10-1 for more information.
61204011L1-1
Designate SNMP hosts to receive SNMP traps from the DSU IV
(one to five entries).
Secure the DSU IV by limiting SNMP network management
access. If enabled, the DSU IV only responds to a user-
configured list of SNMP network managers (one to five
entries).
DSU IV ESP User Manual
Chapter 4. Applications
4-3