Operating Procedure; Turning On/Off The Processor; Monitor Screens - Pentax EPK-i Owner's Manual

4

Operating Procedure

Turning On/Off the Processor

1
Press R on the front of the processor. (Refer to
Figure 4.1.)
•• The processor turns on, the touch panel lights, and the screen
for normal mode appears on the monitor.
I“"Normal Screen”" (P.21)
•• The patient information and user information displayed
immediately prior to turning off the processor last time appear
on the monitor.
2
Press R again to turn off the processor.
After the processor has been turned off, wait at least 30 seconds before turning it back on again. A fuse may be blown
if you turn the power on and off repeatedly within a short period of time.
I“"Replacing the Fuses”" (P.47)
Do not use a sharp object such as the tip of a pen to press the buttons and touch panel on the operation panel.
Do not use the end of the light guide of the scope to operate the buttons or the touch panel.

Monitor Screens

Normal Screen
The normal screen shown below appears on the monitor when you turn on the processor.
Patient’'s Name
(Up to 24 Characters)
ID (Up to 12 Characters)
Image Direction
Film Counter
Comment
(Up to 40 Characters)
Doctor’'s Name
(Up to 12 Characters)
Facility
(Up to 12 Characters)
Age (Up to 3 Characters)
NAME AGE SEX
ID
Comment
Dr.
Facility
Figure 4.1
Sex (1 Character)
2006/OCT/01
16:40:25
EC-380s
100011
Operating Procedure
Date
Time (Hours/
Minutes/Seconds)
Scope Name
Scope Serial
Number
21
4