Table of Contents
Advertisement
4
Operating Procedure
Turning On/Off the Processor
1
Turn on the power switch on the front panel of the
processor. (Refer to Figure 4.1)
• The processor turns on and the screen for normal mode
appears on the monitor.
I "Normal Screen" (P.24)
• The patient information from the last time the processor was
used will be displayed on the monitor.
2
Turn off the power switch when you want to turn off
the power.
Do not turn the power off and then on again within a short period of time. Doing so may blow a fuse.
4
I "Replacing the Fuses" (P.46)
Do not use a sharp object such as the tip of a pen to press the keys on the front panel.
Do not use the end of the scopes' light guide to operate the keys or switches.
Monitor Screens
Normal Screen
The normal screen shown below appears on the monitor when you turn on the processor.
You can change which items appear on the normal screen in the [Display] settings.
I"Settings in the [Display] Tab" (P.35)
Patient's Name
(Up to 24 Characters)
(Up to 12 Characters)
Image Direction
Film Counter
Comment
(Up to 40 Characters)
Doctor's Name
(Up to 12 Characters)
Facility
(Up to 12 Characters)
24
Operating Procedure
Age (Up to 3 Characters)
NAME :
ID :
ID
MIRROR
1
Comment :
Dr. :
Facility :
Figure 4.1
Sex (1 Character)
AGE :
SEX :
08/08/07
15 : 02 : 35
XX-XXX
Date
Time
(Hours/Minutes/
Seconds)
Scope Name
Hide quick links:
Advertisement
Table of Contents
