Table of Contents
Advertisement
installation
14. 3lb of glass crushed glass installed on the burner - there will be
1/2lb leftover.
Glass Crystal amount
15. Install Log 6 onto Log 2 & 4. Log 6 will rest in the notch on Log 2 and
the pin locator on Log 6 should line up with the pin on Log 4.
Log 6 install
16. Install Log 7—the darker end will rest in the notch on Log 5 and the
opposite end will rest on the bed of crushed glass on the burner.
Log 7 install
919-881
54
| RC500EX
6
7
17. Log 7 should touch Log 3 when in position, as shown below.
Log 7 placement
18. Place the glowing wool on the crushed glass as shown below.
Glowing wool placement
Flame picture
Note: If the flame picture on the unit is not satisfactory, move the crushed
glass away from the burner ports as shown below.
3
RC500E
07.04.18
Advertisement
Table of Contents
