Page 1
Wood fireplace insert & Hearth Heater owners & installation Manual www.regency-fire.com MODELS: H2100 I3100L Tested by: Installer: please complete the details on the back cover and leave this manual with the homeowner. Homeowner: please keep these instructions for future reference.
Page 2
The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the reGencY dealer in your area. Keep those reGencY fires burning.
Optional Flue Connector Kit ..........7 Door Gasket ..............14 Masonry and Factory Built Fireplace Clearances ..7 Door Latch Adjustment ..........14 Leg Option on H2100 Hearth Heater ......8 Glass Cleaning ............14 Flue Connector Bracket ..........8 Glass Replacement .............14 Installation Into a Factory Built Fireplace.......8 Glass Removal ............14...
This is a copy of the label that accompanies each note: Regency units are constantly being regency large flush insert. We have printed improved. Check the label on the unit and if a copy of the contents here for your review.
This is a copy of the label that accompanies each note: Regency units are constantly being regency Hearth Heater. We have printed a improved. Check the label on the unit and if copy of the contents here for your review.
Install and use jurisdiction. only in accordance with manufacturer’s installation and operating instructions. Regency Inserts are designed to use either a 5.5" (140mm) or 6" (152mm) flue. fireplace 2) Check your local building codes - Building Inspection Department.
Canada to the front of the unit and 8" (200 mm) to the sides. Clearance diagram for installations If the unit is not raised, thermal floor protec- tion required is 18" (450 mm) in the US and Canada. Regency Wood Insert & Hearth Heater...
6) Once the above items have been checked, slide your insert into position after first po- sitioning the flue liner and offset if required. (Re-install raincap at completion of installa- tion). Diagram 1: H2100M and I3100L Faceplate Assembly Regency Wood Insert & Hearth Heater...
To attach, follow the instructions provided 4) Push the Regency logo plate into the two operation. with the fan holes in the front bottom left corner of the fan.
2) Tilt the first Baffle Brick down and then slide then replace them when cleaning is the 2nd Baffle Brick up and back. Reposition completed. both baffle bricks flat on the air tubes. Regency Wood Insert & Hearth Heater...
(if applicable), To operate fan automatically, push switch on steel corrosion. Overfiring will void your side of fan housing to "Auto" and second switch Regency Wood Insert & Hearth Heater...
The door latch may require adjustment as the is usually not required if a proper installation 7) Your Regency Insert can be very hot. You door gasket material compresses after a few has been done. In the event that removal is re- may be seriously burned if you touch the fires.
Use only high temperature anti seize lube. (ie. never seize) Check glass for cracks Replace if required. Clean blower motor Disconnect power supply. Remove and clean blower. *Do not lubricate* Inspect and clean chimney Annual professional chimney cleaning recommended. Regency Wood Insert & Hearth Heater...
Black Trim Oversize (Set of 3) 395) * Trim Right Oversize 396) * Trim Top Oversize 397) * Trim Left Oversize 398) * Faceplate Side Oversize 399) * Faceplate Top Oversize *Not available as a replacement part. Regency Wood Insert & Hearth Heater...
846-532 Trim Clips 30) * Grommet Strain Relief 836-300 Yellow Insulation 48" x 4" 846-531 Faceplate Hardware Pkg. 35) 120-954 Air Tube Front 36) 120-953 Air Tube Rear *Not available as a replacement part. Regency Wood Insert & Hearth Heater...
81) * Brick Partial: 1-1/4" x 1-1/4" x 9" 84) * Brick Partial: 1-1/4" x 4-1/2" x 8" 85) * Brick Partial: 1-1/4" x 4-1/4" x 8" * Not available as a replacement part Regency Wood Insert & Hearth Heater...
The authorized selling dealer is responsible for all in-fi eld service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers.