Replace The Spiral Cleaner - Canon varioPRINT 135 Series Operation Manual

Replace the Spiral Cleaner

Introduction
When the spiral cleaner is almost full, the control panel displays the orange maintenance icon.
The POC action [Replace the spiral cleaner] becomes active. The table below describes the
meaning of the maintenance icons.
The maintenance icons
Icon
When to do
You can replace the spiral cleaner:
• Immediately or at a convenient time soon, when you cannot wait for the printer to cool down
(for example when your printer is in use 24/7), or
• During a cold start of the printer, for example the next morning when the printer was off or in
sleep mode during the night.
NOTE
When the printer is shut down or put into sleep mode while the orange maintenance icon is
displayed, you must replace the spiral cleaner at the next start-up. Then the red maintenance
icon will be displayed.
Before you begin
1. On the control panel, touch [System] -> [Maintenance] -> [Start maintenance] -> [Replace the
spiral cleaner] -> [Start].
2. [Enter the maintenance PIN.]
3. [Touch Next to unlock the door.]
Wait until the printer is turned off.
4. Put on the heat-resistant gloves in case the machine is warm.
Required tools
Heat-resistant gloves
Socket wrench
New spiral cleaner
CAUTION
Only trained personnel is allowed to carry out POC actions.
Canon varioPRINT 135 Series
Description
Maintenance is required soon. It is advised to replace the spiral cleaner
as soon as possible. You can print about 45,000 more images before re-
placing the spiral cleaner becomes required.
Maintenance is required now. The printer stops. You must replace the
spiral cleaner to resume printing.
Replace the Spiral Cleaner
Chapter 18 - Printer Operation Care (POC) 393