Change The Finishing Method - Canon varioPRINT 135 Series Operation Manual

Change the Finishing Method

Introduction
The required finishing method is usually set in the printer driver. However, you can change the
finishing method on the control panel.
Depending on the configuration of your system you can change the following finishing methods,
for example.
• Number of staples.
• Number of punch holes.
• The location of the staples or punch holes.
NOTE
You cannot change this setting for the active print job .
Procedure
1.
On the control panel, touch [Jobs] -> [Queues] -> [Scheduled jobs] or [Waiting jobs], or go to a
DocBox.
2.
Touch the job you want to change.
3. Touch [Properties], or double-tap the job to open the [Properties] window.
4. Touch the [Binding] button.
5. Make the required changes.
6.
Press [OK].
Canon varioPRINT 135 Series
Change the Finishing Method
Chapter 6 - Carry Out Print Jobs 171