Table of Contents
Advertisement
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller.
The optional settings: [Auto]; [Manual].
'Auto' uses default value: for a root port it is 100 ms, for a hub port the delay is
taken from hub descriptor.
Select [Manual] you can set value for the following sub-item: 'Device power-up
delay in seconds'.
Device power-up delay in seconds
The delay range is from [1] to [40] seconds, in one second increments.
Intel(R) I211 Gigabit Network Connection –
XX:XX:XX:XX:XX:XX
Intel(R) Ethernet Connection (3) I219-LM – XX:XX:XX:XX:XX:XX
This item shows current network brief information.
47
Advertisement
Table of Contents
