JETWAY NF632N Series User Manual page 37

* In the case that user needs to update ME firmware, user should set 'ME FW
Image Re-Flash' as [Enabled], save the settings and exit. The system will turn off
and reboot after 4 seconds. If the user goes to BIOS screen again will find this item
is set again as [Disabled], but user can still re-flash to update firmware next time.
► AMT Configuration
Use this item to configure Intel(R) Active Management Technology Parameters.
Press [Enter] to make settings for the following sub-items:
Intel AMT
Use this item to enable or disable Intel Active Management Technology BIOS
extension.
When disabled AMT BIOS Features are no longer supported and user is no longer
able to access MEBx Setup.
*Note: This option does not disable Manageability Features in FW.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following items shall appear:
Hide Un-Configure ME Confirmation Prompt
Use this item to hide Un-Configure ME confirmation prompt when attempting ME
unconfiguration.
The optional settings: [Disabled]; [Enabled].
MEBx Debug Message Output
Use this item to enable or disable MEBx debug message output.
The optional settings: [Disabled]; [Enabled].
Un-Configure ME
Use this item to enable or disable unconfigure ME with resetting MEBx password
to default.
The optional settings: [Disabled]; [Enabled].
ASF
Use this item to enable or disable Alert Standard Format support.
The optional settings: [Disabled]; [Enabled].
Activate Remote Assistance Process
Use this item to enable or disable Trigger CIRA boot.
32