JETWAY NF632N Series User Manual page 44

Press [Enter] to make settings for the following sub-items:
Serial Port 6 Configuration
Serial Port
Use this item to enable or disable Serial Port (COM).
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the following items:
Device Settings
Change Settings
Use this item to select an optimal setting for Super IO Device.
The optional settings: [IO=2E0h; IRQ=11;]; [IO=3F8h; IRQ=3,4,5,6,7,9,10,11,12;];
[IO=2F8h; IRQ=3,4,5,6,7,9,10,11,12;]; [IO=3E8h; IRQ=3,4,5,6,7,9,10,11,12;];
[IO=2E8h; IRQ=3,4,5,6,7,9,10,11,12;]; [IO=3E0h; IRQ=3,4,5,6,7,9,10,11,12;];
[IO=2E0h; IRQ=3,4,5,6,7,9,10,11,12;].
Serial Port FIFO Mode
The optional settings: [16-Byte FIFO]; [32-Byte FIFO]; [64-Byte FIFO]; [128-Byte
FIFO].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [4] to [255] seconds when 'WatchDog
Reset Timer Unit' set as [Sec]; or in the range of [4] to [255] minutes when
'WatchDog Reset Timer Unit' set as [Min].
WatchDog Reset Timer Unit
The optional settings: [Sec.]; [Min.].
ATX Power Emulate AT Power
39