Table of Contents
Advertisement
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
The default setting is: [AHCI].
SATA
Software Preserve
Port
Use this item to enable or disable each SATA port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
mSATA
Software Preserve
Port
Use this item to enable or disable SATA Port.
The optional settings: [Disabled]; [Enabled].
PCH-FW Configuration
Press [Enter] to view ME information and make settings in the following sub-items:
TPM Device Selection
Use this item to select TPM device: PTT or dTPM.
The optional settings: [dTPM]; [PTT].
Warnning!
PTT/dTPM will be disabled and all data saved on it will be lost.
Firmware Update Configuration
Press [Enter] to make settings for 'ME FW Image RE-Flash'.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
31
Advertisement
Table of Contents
