JETWAY 693AS User Manual page 39

CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
ACPI Function
> Power Management
PM Control by APM
Video Off Option
Video off Method
MODEM Use IRQ
Power Button Function
Power Loss Function
> Wake-Up Events
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
ACPI Function
This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Power Management
Please refer to section 3-8-1
Video Off Option
This determines the manner in which the monitor is blanked. The choice are Suspend → off,
All Modes → Off, and Always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake-Up Events
Please refer to section 3-8-2
Power Management Setup
Enabled
Press Enter
Yes
Suspend -> off
V/H SYNC+Blank
3
Instant-off
Off
Press Enter
F6:Optimized Defaults F7:Standard Defaults
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
36
Item Help
Menu Level >
F1:General Help