Starting Up Your Computer - JETWAY 693AS User Manual

(11) CD Audio-In Headers (4-pin) : CD_IN1, CD_IN2
CD_IN1 and CD_IN2 are the connectors for CD-Audio Input signal. Please connect it
to CD-ROM CD-Audio output connector.

2-7 Starting Up Your Computer

1. After all connection are made, close your computer case cover.
2. Be sure all the switch are off, and check that the power supply input voltage is set to
proper position, usually in-put voltage is 220V∼240V or 110V∼120V depending on your
country's voltage used.
3. Connect the power supply cord into the power supply located on the back of your system
case according to your system user's manual.
4. Turn on your peripheral as following order:
a. Your monitor.
b. Other external peripheral (Printer, Scanner, External Modem etc...)
c. Your system power. For ATX power supplies, you need to turn on the power supply
and press the ATX power switch on the front side of the case.
5. The power LED on the front panel of the system case will light. The LED on the monitor
may light up or switch between orange and green after the system is on. If it compolies
with green standards or if it is has a power standby feature. The system will then run
power-on test. While the test are running, the BIOS will alarm beeps or additional
message will appear on the screen.
5
J2
Infrared Module Headers
C D IN1 : C D-Audio/Panasonic
4 1
C D_IN2 : C D-Audio/Sony
4 1
CD Audio-In Headers
20
1