(8) Wake On-LAN Headers (3-pin) : WOL
This connector connects to a LAN card with a WAKE ON-LAN output.
connector power up the system when a wake up signal is received through the LAN
card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
(9) FAN Speed Headers (3-pin ) : FAN1, FAN2
These connectors cupport cooling fans of 350mA (4.2 Watts) or less, depending on the
fan manufacturer, the wire and plug may be different. The red wire should be positive,
while the black should be ground. Connect the fan's plug to the board taking into
consideration the polarity of connector.
(10) IR infrared module Headers (5-pin) : J2
This connector supports the optional wireless transmitting and receiving infrared
module. You must configure the setting through the BIOS setup to use the IR function.
IDELED
PW BN
SMI
System Case Connections
WOL
1
5VSB
G ND
WO N
3
Wake-On-LAN Headers
1
FAN1
3
1
FAN2
3
19
This