Slow Scanning Speed; There Is Not Enough Memory." Message Is Displayed; Scanned Image Not Displayed Properly - Canon PIXMA MP950 User Manual

Slow scanning speed

Cause
Resolution is set higher than
necessary.
Image correction features such as
dust and scratch reduction, fading
correction, and descreening are
enabled in ScanGear MP.

"There is not enough memory." message is displayed

Cause
There is not enough memory to
continue scanning.

Scanned image not displayed properly

Cause
Scanned image prints out enlarged
(reduced).
Scanned image enlarged (reduced)
on the computer monitor.
Chapter 12
To view the image on a monitor, set the output resolution to 75 dpi. To
print, set the output resolution to a value such as 300 dpi.
Set [Reduce Dust and Scratches], [Fading Correction], and [Descreen] to
[OFF] in the [Image Settings] section of the Advanced Mode of ScanGear
MP.
Exit any application software that are running, and try to run this software
again.
Set the printing size in the application software.
Example: ArcSoft PhotoStudio
1. With the image in the selected state, click the [File] menu and select
[Print].
2. Move the print size slider left or right in the Print dialog to adjust the
printing size. The preview image to the left will change size accordingly.
Change the display setting in the application software.
Images opened in [Paint] or [Imaging] may be displayed in full size and
you may not be able to reduce its display size. Open the image in an
application software supplied with the scanner instead. Refer to the on-
screen manual for each application software for the detailed
procedures.
Change the resolution setting in the scanner driver and rescan. The
higher the resolution, the larger the resulting image will be.
Some application software do not display clear images at small image
display settings. Set the scale to 100%.
Action
Action
Action
Troubleshooting 139