Wired Network Setups; Connect Your Rover Ap To The Rover Router Using A Wired Connection - ZyXEL Communications NBG7510 User Manual

Table 10 Link Quality
ICON

6.4 Wired Network Setups

• Connect your Rover AP to a router (the Rover Router as an example).
• Connect your Rover Router to an access point (the WRE6605 AP as an example).

6.4.1 Connect your Rover AP to the Rover Router Using a Wired Connection

Follow the steps below to set up your Rover AP with arouter (the Rover Routeras an example). Connect
the Rover Router to the Internet. The Rover Router must be connected to a modem/router using an
Ethernet cable. Then, connect a LAN port on the Rover AP to a LAN port on the Rover Router using
another Ethernet cable.
Table 11 Device Role
DEVICE
Zyxel Device in Router mode
Zyxel Device in AP mode
Note: Make sure you reset the Rover Router and Rover AP to factory defaults before switching
to a different mode. Remember to back up your configuration setting before resetting
your devices to factory defaults. See
1 Turn on your modem/router for Internet access. Connect an Ethernet cable from a modem /router to
the WAN port on the Rover Router.
2 Note the power LEDs when you're done. The power LEDs should be steady blue. Place the Rover AP
where you want WiFi coverage and connect it to the Rover Router using an Ethernet cable.
3 Download the app to your smartphone and log into the Rover Router's WiFi network using the default
label information on the back label. You may need to forget your current WiFi connection on your
smartphone.
Chapter 6 Rover App Tutorials
CONNECTION TYPE WIFI STATUS
Wired Wired Connection
Wired Blocked
Wireless Good to Go
Wireless Too Close to the Router
Wireless Weak WiFi
Wireless Blocked
TERM
Rover Router
Rover AP
Section 2.2 on page 22
NBG7510 User's Guide
62
ROLE
Router
Access Point
for more information.