ZyXEL Communications NBG7510 User Manual page 64

Note: Make sure you reset the Zyxel Device and WRE6605 to factory defaults before switching
to a different mode. Remember to back up your configuration setting before resetting
your devices to factory defaults. See
1 Turn on your modem/router for Internet access. Connect an Ethernet cable from a modem/router to the
WAN port on the Rover Router.
2 Note the power LEDs when you're done. The power LEDs should be steady blue. Place the WRE6605 AP
where you want WiFi coverage and connect it to the Rover Router using an Ethernet cable.
3 Download the Rover app to your smartphone and log into Rover Router's WiFi network using the default
label information on the back label. You may need to forget your current WiFi connection on your
smartphone.
4 Change the default SSID and WiFi key on the Rover Router for better WiFi security; see
page 66 for more information. After applying changes, you will need to reconnect to the Rover Router
again using the new SSID and WiFi key.
5 Use WPS to copy the SSID and WiFi key from the Rover Router to the WRE6605 AP. Press the WPS button
on the Rover Router for 1.5 to 4 seconds and then press the WPS button for 2 seconds on the WRE6605
AP within 120 seconds.
6 Use the Rover app and the table below to see if the access point is securely connected to the router;
see Section 6.8 on page 71
Table 14 Link Quality
ICON CONNECTION TYPE WIFI STATUS
Wired
Wired
Wireless
Wireless
Wireless
Wireless
Chapter 6 Rover App Tutorials
Section 2.2 on page 22
for more information.
Wired Connection
Blocked
Good to Go
Too Close to the Router
Weak WiFi
Blocked
NBG7510 User's Guide
64
for more information.
Section 6.7.1 on